Fuel additives

ASPOFORM NA      (viscosity 7,5 cSt  @40°C)
Non-aromatic concrete mould oil. Releases concrete out of mould leaving the mould maintains unchangeable from casting to another. The surface of the concrete becomes smooth and thete is no discoloration. The paint, wallpaper and sand plaster adheres well to concrete surface.

ASPOFORM NA-R     (viscosity 7,5 cSt  @40°C)
Acts as mold parting agents berween mould and pourable concrete inhibiting the rusting steel moulds. NA-R is used as is without mixing it into the water and it adapts for use in steel-, wooden and plywood moulds. Spread by spraying or by brush. When spraying the adequacy of Aspform NA-R is 10-15 sqm by one litre. The mould oil should be speared thinly everywhere on the mould face.

ASPOWAX NA-X     (viscosity 7,5 cSt  @40°C)
Non-aromatic concrete mould oil. Acts as mold parting agents berween mould and pourable concrete. Aspowax NA-X is used as is without mixing it into the water and it adapts for use in steel-, wooden and plywood moulds. It gives very good and smooth surface and suits also for complicated shaped moulds and other applications which are difficult to release. Spread by spraying or by brush. When spraying the adequacy of Aspform NA-R is 30-50 sqm by one litre.

ASPOFORM BIO     (viiscosity 12 cSt  @40°C)
Biolologically dissolving mould release oil. For use in steel-, wooden and plywood moulds. Acts as mold parting agents berween mould and pourable concrete inhibiting the rusting steel moulds.

ASPOFORM NA-L     (viscosity 3,4 cSt  @40°C)
Non-aromatic mould oil of which follows that there is no for respiratory organs harmful oil in the air space in the working place.Meant to be used in manufacturing floor tiles, grates or kerbs, when the pieces are released wet. NA-L guarantees an easy release from the mould, the surface of the pieces is smoth and the concrete does not adhere to the mould.